
Rev. __________
Date _________
0.1
NOTICE
MANUFACTURED BY:
DATE OF MANUFACTURE_____mo. _____yr.
INCOMPLETE VEHICLE MANUFACTURED
BY:
DATE INC. VEH. MFD. _____mo.
_____yr.
GVWR _______________________________
GAWR FRONT _____________________ with
__________________________________tires,
_____ rims, @ _____ psi cold _____________
GAWR INTERMEDIATE (1) ____________with
__________________________________tires,
_____ rims, @ _____ psi cold _____________
GAWR INTERMEDIATE (2) ____________with
__________________________________tires,
_____ rims, @ _____ psi cold _____________
GAWR REAR ______________________with
__________________________________tires,
_____ rims, @ _____ psi cold _____________
Conformity of the chassis-cab to Federal Motor
Vehicle Safety Standards, which have been
previously fully certified by the incomplete vehicle
manufacturer or intermediate vehicle manufacture,
has not been affected by final-stage manufacture.
The vehicle has been completed in accordance
with the prior manufacturer’s instructions, where
applicable. This vehicle conforms to all other
applicable Federal Motor Vehicle Safety Standards
in effect in:
_____mo.
_____yr.
VEHICLE IDENTIFICATION NUMBER:
VEHICLE TYPE: ________________________
This certification sticker appears on every Jerr-Dan unit mounted on a new chassis and
is required by law. Jerr-Dan Corporation will not certify any unit for a capacity greater than
the chassis manufacturer’s specified rating. The capacity ratings of Jerr-Dan units do
not imply that vehicles can be used without regard to gross vehicle weight ratings
(GVWR) or gross axle rating limitations.
The payload carrying capacity of any truck is determined by the GVWR of the cab
chassis, the curb weight of the cab chassis and the weight of the body. It is important that
you determine that your truck has satisfactory carrying capacity and axle ratings for your
specific application. Jerr-Dan’s authorized sales representatives are available to assist
you in this regard.
Comentarios a estos manuales