Carrier 58DHL Manual de usuario

HEATING A COOLING58DHLDownflow/Horizontal Induced-Combustion FurnacesInstallation, Start-Up and Service InstructionsSizes 055-115 = ~ —NOTE: Remove

Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obiigations.B°°k

Table 2—Dimensions (in inches)SizeA DEVent Conn055BC14^,6127,612”/,64055CC14=/i6127,612’7,64OrSBC1772157a16 4075CCV'k157fc16 4095CCM'k 157s1

Fig. 7—Furnace, Plenum, and Base Installed on a Combustible Floor2.3.Cut and frame hole in floor per dimensions in Table 1 of Installation Instructio

hanger bolts (Four each %-in. all-thread rod) cut to desired length, 1 X % flat washer, % lockwasher, and % nut. Dimples are provided for hole locatio

cn1 KUKM)lA-TRANSKOUMKK. t>i'VACV->-IVAC:>n- iNDi CKH MciTOH m>sr-\ o2K-KtL\v HKAi is'; m.uwKH {MHO Si’M s <~ UKLAV CO(ll.!\

Fig. 13—Amp Draw Check With Ammetercorrespond to that specified on the unit rating plate. Also, check to be sure that the service provided b

to the outside, or exposed to air currents from warm- or cold-air registers; or to exposure where the natural circulation of the air is

The ability to properly perform maintenance on this equipment requires certeun mechanical skUls and tools. If you do not possess these, contact your

(4.) Remove metal screw fitting from wire brush to allow insertion into cable, b. Clean each heat exchanger ceU.(1.) Attach variable-speed reversible