Carrier TP-NHP Manual de usuario descargar pdf (Pagina 22)

A07219

Fig. 14 − Equipment Control Module

5. Match and connect equipment wires to proper terminals of each connector

block.

6. Push any excess wire into wall and against Equipment Control Module.

Seal hole in wall to prevent air leaks. Leaks can affect operation and cause

incorrect temperature measurement.

7. Remove 2−wire pigtail from thermostat mounting base and attach to

Equipment Control Module terminal block (terminals V+ and Vg). Attach

2−wire pigtail to the back of the Display Module via 2 pin, keyed connec-

tor.

8. Reattach Display Module body to Equipment Control Module by first

setting on at top and then push bottom corners to snap into place. See Fig.

15.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Sin comentarios

Carrier TP-NHP Manual de usuario Pagina 22