Carrier TP-NHP Manual de usuario descargar pdf (Pagina 41)

TO TEST FAN

Fan button switches FAN icon between AUTO and On. While On is displayed,

G output will be energized, turning fan on. On some fan coils, fan continues to

operate for 90 sec after G signal is removed.

Final Settings

Be sure to press DONE to exit installer setup mode. If the system is to be left in

operation after installation is complete, use MODE button to select between

HEAT, COOL, or AUTO to provide desired operation of heating, cooling, or

auto.

On the programmable models, the default setpoints and programmed schedule

conform to the Energy Star requirements of the U.S. Department of Energy for

both heating and cooling. These provide energy saving temperature settings.

Refer to Table 1.

Table 1 – Energy Star Default Schedule

SCHEDULE HEAT COOL

Wake 6:00 AM

68F/20C 78F/26C

Day 8:00 AM

60F/16C 85F/29C

Evening 5:00 PM

68F/20C 78F/26C

Sleep 10:00 PM

60F/16C 82F/28C

If the programmed schedule is to be used, make sure the triangle icon next to the

FOLLOW SCHEDULE icon is turned on. Pressing the Schedule button will

cycle the triangle icon through the FOLLOW SCHEDULE, HOLD and

VACATION selections.

If fixed temperatures are desired, use SCHEDULE button to turn on arrow icon

next to HOLD. This will maintain setpoints, not allowing them to change with

programmed schedule.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 63 64

Sin comentarios

Carrier TP-NHP Manual de usuario Pagina 41