Carrier 52F Series Manual de instalación Pagina 10

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 50
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 9
8
PREINSTALLATION INSTRUCTIONS:
Please read ALL instructions before installing. Two people are recommend to install this product. If a new
electrical outlet is required, have the outlet installed by a qualied electrician before installing unit.
Step 1) Using the following table, nd your wall-sleeve brand of your installation.
Brand
Dimensions
W x H
x D
Page Brand
Dimensions
W x H
x D
Page
White-Westinghouse
Frigidaire
Carrier (52F Series)
25½” x 15¼” x
16” OR 17½”
OR 22”
17
Sears/Kenmore
Carrier(51S Series)
25¾“ x 16
x 18
14
General Electric
Hotpoint
26” x 15
x 15
14
Fedders
Emerson
26¾” x 15¾”
x 15”
10
Whirlpool
25 x 16½”
x17
15
Fedders, Emerson
Friedrich
27 x 16¾”
x 16¾”
12
Whirlpool
25 x 16½”
x23”
16
Fedders
Emerson
27” x 16¾”
x19¾”
11
NOTE: All wall sleeves used to mount the new air conditioner must be in
sound structural condition and have a rear grille that securely attaches to
sleeve, or rear ange that serves as a stop for the air conditioner.
CAUTION: When installation is complete, replacement unit MUST have a
rearward slope as shown.
Step 2) Remove old air conditioner from wall sleeve and prepare wall sleeve as follows:
• Clean interior (do not disturb seals).
Wall sleeve must be securely fastened in wall before installing air conditioner.
• Drive more nails or screws through sleeve, into wall, if needed.
• Repair paint if needed.
Step 3) Remove old air conditioner from wall sleeve and prepare wall sleeve as follows:
If a grounding wire is not already place, drill a 1/8 clearance hole for the grounding screw through left side
of wall sleeve, in a clear area about 3 inches maximum back from front edge of sleeve, using the grounding
screw and toothed washer.
Pull loose end of ground wire out front of sleeve, and temporarily bend it down and around lower edge of
sleeve. This ground wire will later be attached to frame of air conditioner once it is installed.
Step 4) Begin specic wall sleeve preparations based on the instructions referenced in the above table.
Vista de pagina 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 49 50

Comentarios a estos manuales

Sin comentarios