Carrier 52F Series Manual de instalación descargar pdf (Pagina 8)

FAN ONLY MODE:

• Use this mode when you’d like to circulate air or

exhaust stale air but not run the air conditioner.

• Open the vent in fan mode, but for most eciency

keep it closed during cooling mode.

• The display shows the ambient room temperature.

DRY MODE:

• The unit functions as a dehumidier in dry mode.

• Some cooling may occur during this mode.

ENERGY SAVE FEATURE:

• With a press of the Energy Save button, the fan

continues to blow air through the compressor anr

provide cooled air. The fan will run for 2 minutes

every 10 minutes, and cooling will resume once the

room temperature exceeds the set temperature.

SLEEP MODE FEATURE:

• When you push the sleep button, the selected tem-

perature will increase (cooling) or decrease (heat-

ing) by 1°C/2°F after 30 minutes. The temperature

will then increase (cooling) or decrease (heating) by

another 1°C/2°F after an additional 30 minutes.

• The new temperature will be maintained for 7

hours before it returns to the originally selected

temperature. This ends Sleep mode and the unit

will continue to operate as originally programmed.

TIMER & AUTO START/STOP FEATURE:

• The timer indicator lights are for two separate

functions, one to automatically turn the unit on and

another to automatically shut it o. Both programs

can be set at the same time.

Setting the unit to automatically turn o:

• Push the timer button once (if dehumidier is run-

ning) or twice (if dehumidier is not running) until

the ‘OFF’ indicator illuminates

• Use the + and – pad to select the number of hours

before the unit automatically turns o.

• The time will be programmed after 5 seconds of

inactivity and the display will return to show the

humidity level.

Setting the unit to automatically turn on:

• Push the timer button once (if dehumidier is not

running) or twice (if dehumidier is running) until

the ‘ON’ indicator illuminates.

• Use the + and – pad to select the number of hours

before the unit automatically turns o.

• The time will be programmed after 5 seconds of

inactivity and the display will return to show the

humidity level.

NOTE: Both ‘ON’ and ‘OFF’ indicators can be illumi-

nated—the unit will automatically turn itself on and

o according to the programmed times.

PERSONAL MAPPING TEMPERATURE SENSOR:

• NOTE: This feature can be activated from the

remote control ONLY and on select models.

The remote control acts as a remote thermostat

allowing for the precise temperature control at its

location.

• To activate the personal mapping temperature

sensor, point the remote control towards the unit

and press the PMTS button. The remote display

is actual temperature at its location. The remote

control will send this signal to the air conditioner

every 3 minutes interval until press the PMTS

button again.

• If the unit does not receive the remote signal

during any 7 minutes interval, the unit will beep

to indicate the personal mapping temperature

sensor mode has ended.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 49 50

Comentarios a estos manuales

Sin comentarios

Carrier 52F Series Manual de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Carrier 52F Series