Carrier 38VBH Manual de instalación descargar pdf (Pagina 10)

42PQV/38VBH

GB - 9

ENGLISH

• The piping can be connected in the four ways indicated by ,

,  and .

When the piping is connected to points ,  or , remove

the knock-out either at the side or at the bottom of the unit.

IMPORTANT NOTE:

Indoor unit has no refrigerant expansion device.

Installing the wall hanging bracket

• Install the wall hanging bracket so that it is level. Use a plumb

line if necessary.

• Be sure to leave the clearance spaces. (Refer to page 4).

• If the wall hanging bracket is not level, water may drip onto the

floor.

• Install the wall hanging bracket with a fixing that is strong

enough to withstand the weight of the unit.

• Before installing the wall hanging bracket, remove it from the unit

by pushing at the indicated parts at the bottom of the body.

• Fasten the wall hanging bracket to the wall with 4 or more screw

anchors through the holes near the outer edge of the bracket.

• Install the wall hanging bracket so that there is no gap between

the bracket and the wall.

• Check that the wall hanging bracket does not move.

This can cause noise during operation.

• If the unit is removed from the wall hanging bracket after installing

it onto the wall, remove it by pushing up the indicated MARKS

(

) at the bottom of the body. (Refer to page 10).

Marking the wall penetration for the

connection piping

Rear piping

• It is best for the piping to go through the wall behind the unit, so

that the unit hides the pipes.

• For this method of installation, make a 65 mm diameter hole in the

wall at point A.

• Drill a 65 mm diameter hole at a slope so that the outside end is

lower (5 - 10 mm) than the inside end.

This will ensure good drainage.

• Cut the wall sleeve to match the wall thickness and pass the pipe

through the hole.

Side or bottom piping

• Remove the knock-out in the unit and pass the pipes through

the wall.

• The pipe should slope downward and away from the unit to

ensure good drainage.







 Indoor side

 Outdoor side

 5 ~ 10 mm lower



 Remove screw



 Plumb line

300

min.

120 min.

450

min.

450

110

245

110

260

180

Installation for indoor unit

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Comentarios a estos manuales

Sin comentarios

Carrier 38VBH Manual de instalación Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Carrier 38VBH