Carrier 38VBH Manual de instalación descargar pdf (Pagina 11)

42PQV/38VBH

GB - 10

Routing the drain hose and refrigerant

piping

• Tie together the refrigerant pipe, the drain hose, and the

electrical connection cord.

• Route the refrigerant piping in the required direction, and bend

carefully avoiding pipe deformation.

Bind the drain hose and the electrical connection cord together

with fastening tape.

The drain hose should be at the bottom.

• For left-hand piping, fit the pipes and the wiring into the recess at

the back of the unit.

NOTE:

• Do not crush or kink the indoor piping. Avoid sharp bends with a

bend radius of less than 100 mm.

• Do not bend the same part of the pipe too often.

• Do not remove the flare nut from the indoor unit pipe until the

piping is connected.

• The recommended bending of the drain hose is shown.









 Indoor unit piping

 Left-hand piping

 Bind with fastening tape

 Drain hose

 Indoor unit piping

 Drain hose

 Connection cord













 Wall hanging

bracket

 Hook

 Hole

Installation for indoor unit

300

220

Installing the indoor unit body to the wall

hanging bracket

• Pass the pipes through the wall sleeve and then hook the indoor

unit body on top of the wall hanging bracket.

• For left-hand piping, hang the unit on top of the wall hanging

bracket and incline the unit using a tool such as a screwdriver

set between the middle area of the body and bottom right of the

wall hanging bracket.

Connecting the pipe can be done more easily if the unit is

inclined.

• Fix the bottom part of the unit to the wall hanging bracket, by

pushing it carefully unit the two bracket hooks fit into the marked

places at the base of the unit (a click will be heard).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Comentarios a estos manuales

Sin comentarios

Carrier 38VBH Manual de instalación Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Carrier 38VBH