Carrier 52S series Manual de usuario descargar pdf (Pagina 19)

Accessory Retrofit Kit for GE

Sleeve

Part No.: GE-RETROFIT-KIT

This kit contains the items that allow owners to install

a 52S chassis into a plastic or metal GE sleeve so that

there is no air leakage or damage to 52S unit compo-

nents. The Retrofit Kit is an accessory and must be

ordered separately from the factory.

To retrofit to a plastic GE sleeve, it is important to

remove the rear bottom seal from the sleeve. To retro-

fit to a metal GE sleeve, a metal rail extension bracket

must be mounted to the bottom of the sleeve.

Both metal and plastic sleeves require placing two

foam baffles (provided in the Retrofit Kit) on the out-

door condenser coil. These baffles must be installed to

prevent air recirculation.

Refer to the installation instructions for complete

installation procedures.

IMPORTANT: The foam baffles must make a good

seal between the grille and outdoor coil. Improper

installation of the foam baffles or neglecting to

install them can result in condenser (outdoor) air

recirculation. This will degrade the unit’s perfor-

mance and shorten product life. Do not ignore this

step.

Carrier does not assume responsibility for costs

or damages resulting from misapplication of foam

baffles.

REAR BOTTOM SEAL

GE SLEEVE

SLEEVE

INSTALLED RAIL

EXTENSION BRACKET

Location of Foam Seal to be Removed

from GE Plastic Sleeve

Installation of Rail Extension Bracket

Placement of Foam Baffles on Outdoor Coil Tube Sheets

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Sin comentarios

Carrier 52S series Manual de usuario Pagina 19