Carrier 52S series Manual de usuario descargar pdf (Pagina 25)

TYPICAL WALL AND DEEP WALL INSTALLATION

NOTES:

1. Sleeve may be flush mounted to floor, but front panel may

have to be notched to accommodate service cord.

2. If more than 4 in. of sleeve projects into room, an accessory

subbase must be used for support.

3. For walls 2 in. thick or less, an accessory subbase must be

used for support.

Typical Wall Installation

NOTES:

1. To permit outdoor grille to be attached to and supported

by unit sleeve, fabricate a sleeve extension so unit sleeve

and baffles can reach outdoor grille. Be sure to provide

flashing for proper condenser runoff to avoid water dam-

age to room interior. Internal or external drain system may

be required.

2. Baffles may be part of the sleeve extension or fixed

directly to condenser coil tube sheets.

3. Caulk all joints between sleeve or baffles and opening in

wall.

4. If grille is used on outdoor wall opening,

do not

install an

additional outdoor grille on unit sleeve.

Typical Deep Wall Installation

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Sin comentarios

Carrier 52S series Manual de usuario Pagina 25