Carrier PERFORMANCETSERIES EDGER THERMIDISTATT CONTROL TP-NRH-A Manual de instrucciones descargar pdf (Pagina 19)

A07227

Fig. 12 -- Standoff

NOTE: Standoffs are provided as an aid when installing Equipment Control

Module on inside equipment or a solid wall.

12. Match and connect equipment wires to proper terminals of each connector

block being careful not to over tighten the screws. Correct polarity must

be observed when connecting the two wires from the Equipment Control

Module to the Thermidistat Control mounting base. If wires are con-

nected incorrectly, the Display Module will not operate. See Fig. 7, 8 and

13. Snap cover over top of Equipment Control Module. See Fig. 13.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 83 84

Sin comentarios

Carrier PERFORMANCETSERIES EDGER THERMIDISTATT CONTROL TP-NRH-A Manual de instrucciones Pagina 19