Carrier 52S series Manual de usuario descargar pdf (Pagina 17)

ORDERING DATA (cont)

Drain Kit

Part No.: DRAIN-KIT-4PK

This universal drain kit may be used internally or ex-

ternally to route condensate to a drainage system. It

can be ﬁeld-installed on the Carrier wall sleeve.

Although Carrier’s units are designed to dissipate all

the condensate generated during normal cooling, there

may be times when abnormal conditions cause more

condensate than the unit can dissipate. Heat pumps some-

times generate condensate that the unit may not be de-

signed to handle. If condensate that drips from the wall

case is objectionable, this internal/external drain kit

should be installed.

The drain kit may be attached to the exterior right or

left side of the wall sleeve for external draining or may

be mounted to the room side of the wall sleeve for in-

ternal draining.

Drain Kit

Hard-Wire Kit

Part No.: H/W-KIT-230V

Part No.: H/W-KIT-230V-4PK

Part No.: H/W-KIT-265V

Part No.: H/W-KIT-265V-4PK

This accessory hard-wire kit provides a permanent con-

nection to the unit. Electrical hard wiring is required

when NEC (National Electrical Code) or local codes

restrict the use of power cord and plug connections.

The hard-wire kit mounts on the right side of the unit

and comes with 42 inches of ﬂexible steel conduit, an

electrical junction box, and a unit-mounted connector.

The 230 volt kit comes with an additional plug assem-

bly to use when replacing the 230-volt cord.

Hard-Wire Kit

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 48 49

Sin comentarios

Carrier 52S series Manual de usuario Pagina 17