Carrier 52S series Manual de usuario descargar pdf (Pagina 21)

ORDERING DATA (cont)

Accessory Retroﬁt Kit for GE

Sleeve

Part No.: GE-RETROFIT-KIT

This kit contains the items that allow owners to install

a 52S chassis into a plastic or metal GE sleeve so that

there is no air leakage or damage to 52S unit compo-

nents. The Retroﬁt Kit is an accessory and must be or-

dered separately from the factory.

To retroﬁt to a plastic GE sleeve, it is important to re-

move the rear bottom seal from the sleeve (Figure A).

To retroﬁt to metal sleeves, remove the metal clip on

the GE mounting rail and install the metal bracket pro-

vided in the Retroﬁt Kit (Figure B).

Both metal and plastic sleeves require placing two foam

baffles (provided in the Retroﬁt Kit) on the outdoor

condenser coil tube sheets, one baffle on each tube sheet

(Figure C). These baffles must be installed to prevent

air recirculation.

BOTTOM SEAL

GE SLEEVE

A. Location of Foam Seal to be Removed from

GE Plastic Sleeve

SLEEVE

GE MOUNTING RAIL

METAL CLIP

SLOT

INSTALLED BRACKET

B. Bracket to be Attached to GE Metal Sleeve

C. Placement of Foam Baffles on Outdoor Coil Tube Sheets

Refer to the installation instructions for complete in-

stallation procedures.

IMPORTANT: Be sure that the foam baffles make

a good seal between the grille and outdoor coil tube

sheets. Improper installation of the foam baffles or

neglecting to install them can result in condenser

(outdoor) air recirculation. This will degrade the

unit’s performance and shorten product life. Do not

ignore this step. Carrier does not assume responsi-

bility for costs or damages resulting from misappli-

cation of foam baffles.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 48 49

Sin comentarios

Carrier 52S series Manual de usuario Pagina 21