Carrier 52S series Manual de usuario descargar pdf (Pagina 27)

DIMENSION DRAWINGS AND INSTALLATION

DATA — NEW CONSTRUCTION (cont)

NOTES:

1. Sleeve may be ﬂush mounted to ﬂoor, but front panel may

have to be notched to accommodate service cord.

2. If more than 4 in. of sleeve projects into room, an acces-

sory subbase must be used for support.

3. For walls 2 in. thick or less, an accessory subbase must

be used for support.

Typical Wall Installation

NOTES:

1. To permit outdoor grille to be attached to and supported

by unit sleeve, fabricate a sleeve extension so unit sleeve

and baffles can reach outdoor grille. Be sure to provide

ﬂashing for proper condenser runoff to avoid water dam-

age to room interior. Internal or external drain system may

be required.

2. Baffles may be part of the sleeve extension or ﬁxed di-

rectly to condenser coil tube sheets.

3. Caulk all joints between sleeve or baffles and opening in

wall.

4. If grille is used on outdoor wall opening,

do not

install an

additional outdoor grille on unit sleeve.

Typical Deep Wall Installation

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 48 49

Sin comentarios

Carrier 52S series Manual de usuario Pagina 27