Carrier 42 HQX Manual de usuario descargar pdf (Pagina 6)

alternate PTT method the only serial PTT method that works.

Once you've entered a port value you may press the Test PTT button to perform an RX to TX

to RX cycle. No audio will be sent to your rig during this test so, less any noise on the audio

line, you should not actually transmit any signal.

If using PTT via Rig Control you will be limited to using HRD as your rig control method as it

is, so far, the only rig control interface with full functionality for controlling PTT. It is also

presently the only interface that allows sending values to your rig from JT65-HF. At this time

OmniRig and DX Labs Commander only support reading the rig's dial frequency.

For the most reliable setup I suggest not using rig control and using a serial interface PTT

device or VOX, but, many (myself included) have had great success using full rig control.

Rig control setup begins with selecting a method. As stated above you must use HRD if you

wish to control PTT via rig control (or in the Icom world CAT control). If you presently use

HRD and can control PTT via it or DM-780 you should have no difficulty doing the same with

JT65-HF.

If using HRD you will need to determine if you're running the older HRD version 4 or newer

version 5 code. In my (limited) testing I've found that selecting version 5 support will work

with HRD V4 and V5 but selecting version 4 will only work with HRD V4. To determine the

version of HRD you have installed you may select the Help menu in HRD and click on About...

to be presented with the needed information.

Once you've selected the appropriate HRD version support you may enable it by ticking the

check-box labeled Enable. Please insure that HRD is running on your computer and properly

communicating with your rig before doing this.

Assuming all is well you will then be presented with a window similar to that pictured above.

You may not see all controls in the example as not all rigs support the same control set

available on my rig (for instance, some don't have the controls for audio levels, power level so

those would not appear).

Note: In the example graphic I have set JT65-HF to access HRD on a second

computer. Normally you would always use the default value of localhost for HRD

Server Address and port 7809! Only change those values if you absolutely know you

need to. If you do change the address/port values you will need to disable HRD

support and re-enable to have the change take effect.

If JT65-HF is able to connect with HRD you should, at least, see the caption change to HRD

Connected to some rig and the Rig QRG Hz input box should show your rig's dial frequency

setting. You may or may not see an S-Meter indication as some rigs don't convey this and

others don't (yet) work with JT65-HF. Much of this support is totally new for version 1.0.7 and

is still a work in progress.

If you wish to use PTT via HRD you may test its function with the Test HRD PTT button and, if

it works, then enable its use with the Use HRD for PTT check box. If you do not see either

the button for testing HRD PTT or the check box for enabling it HRD has reported to JT65-HF

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Sin comentarios

Carrier 42 HQX Manual de usuario Pagina 6