Carrier 42 HQX Manual de usuario descargar pdf (Pagina 7)

that your rig does not support PTT control.

If you would like to test changing your rig's frequency you may enter a value in HERTZ and

push the set QRG button. Future versions will allow entering frequency values in other units,

but, for now you must do so in Hertz, for example, 21076000.

Shift QRG to match DF if TxDF matching enabled will become available in JT65-HF 1.0.8 as

it's simply not quite ready for general use. Once available, this will enable a VFO QSY to

match your frequency to a station you're calling versus the current method of shifting your

audio tones to zero beat.

This leaves the boxes for automatic QSY functionality. If you wish to QSY on some schedule

you may set a UTC hour and minute for the QSY, enter the frequency in HERTZ and tick the

check box to the left side of the parameters. In version 1.0.8 the ability to run an auto

antenna tune cycle upon QSY and/or change to different antenna selection(s) will be enabled

for those rigs supporting those functions. Again, those items aren't quite ready for 1.0.7.

Alternate rig control methods – OmniRig and DX Labs Commander.

Follow the instructions accompanying the software, confirm it works, insure the desired

program is running and enable.

Again, please note that with OmniRig and Commander you will only be able to read

your rig's frequency. I hope to provide full support as seen with HRD in later versions

for Commander then OmniRig.

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Sin comentarios

Carrier 42 HQX Manual de usuario Pagina 7