Carrier operating and maintanance Especificaciones descargar pdf (Pagina 24)

5-376-000097

REV. 1 - 12/08

Section I: Safety

Page 14

• Don’t use a recovery vehicle that has not

been properly maintained. Make sure

mounting bolts are tight and moving parts

are lubricated.

• Become familiar with the loads that your

unit can safely transport without exceeding

the structural rating of the Jerr-Dan

equipment or the gross axle weight ratings,

gross vehicle weight rating, and the gross

combined vehicle weight rating of your

chassis.

• After you have placed a vehicle on the

carrier for towing, don't start the tow until

you have installed tie-down straps and

chains.

• Read operating and loading instructions

thoroughly.

• Don’t operate the engine faster than

recommended. Excessive speeds can

damage PTO, hydraulic pumps, and winches.

• NEVER travel with the PTO engaged. Damage

to the recovery vehicle's transmission and

hydraulic components will occur. Engage the

PTO only when operating the controls.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 115 116

Sin comentarios

Carrier operating and maintanance Especificaciones Pagina 24