Carrier operating and maintanance Especificaciones descargar pdf (Pagina 73)

5-376-000097

REV. 1 - 12/08

Section II: Operation

Page 63

15. Make sure that the far end of the

vehicle has enough ground

clearance. It is possible to set

the rear of a front lifted vehicle

completely on the ground. Take

irregular road surfaces into

consideration. Make sure that

there are no under body

components of the vehicle in

contact with the L-Arms or wheel

grid device. Readjust if

necessary.

16. Lower the Tow Option Extend/

Retract control handle to retract

the wheel lift until the vehicle is

about 3 to 4 feet from the back

of the truck. Leave enough room

to maneuver around corners

without corner binding or causing

contact between the (2) vehicles.

Be sure that the boom is

extended adequately to ensure

unobstructed crossbar pivoting.

17. Be sure to maintain sufficient

clearances with the bottom of the

vehicle.

18. Attach the safety chains and

magnetic towing lights. The

safety chains are located in the

chain boxes at the rear of the

recovery vehicle. Safety chains

should be must from one side

of the carrier vehicle to the

opposite side of the casualty

vehicle.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 115 116

Sin comentarios

Carrier operating and maintanance Especificaciones Pagina 73