Carrier operating and maintanance Especificaciones descargar pdf (Pagina 54)

5-376-000097

REV. 1 - 12/08

Section II: Operation

Page 44

WINCH OPERATION - MANUAL REMOTE FREE-SPOOL

Follow these simple steps to

disengage the winch:

1. To disengage the winch clutch,

raise the Winch Control handle

to run the winch in the reverse

(reel out) direction until the load

is off the wire rope/cable. Never

pull the free spool knob while

the wire rope/cable is under

load. Raise and lift the free

spool knob and pull it toward

you.

2. Then lower the knob and release.

3. Look to make sure that the free

spool knob is locked in the free

spool position. The winch clutch

is now disengaged and the wire

rope/cable may be pulled off by

hand.

WARNING:

Maintain a minimum of five (5)

wraps of wire rope/cable on the

winch drum at all times. Also

maintain a uniform wrap of wire

rope/cable on the drum to avoid

crushing of the wire rope/cable.

WARNING:

Always wear gloves when

handling wire rope/cable.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 115 116

Sin comentarios

Carrier operating and maintanance Especificaciones Pagina 54