Carrier operating and maintanance Especificaciones descargar pdf (Pagina 95)

Section III: Maintenance

Page 85

5-376-000097

REV. 1 - 12/08

• All torque values shown are for bolts (cap screws) and nuts that are either zinc-

plated or lubricated.

• Torques shown above apply only to screws and nuts used for assembly and

installation of all carrier components, not to the chassis.

• Different torque values may be given in instructions for certain components due to

short thread engagement or low-strength internal threads.

• When nuts are used, tighten nuts to torques shown (screws or bolts should be

held but not turned). Always use a calibrated torque wrench.

• Retighten nuts of all mounting screws that secure the carrier and carrier-body

within 30 days after putting the vehicle into service. Thereafter, inspect and

retorque such screws and nuts every 90 days and after each job that imposes

extremely heavy loads on the equipment.

• Convert ft/lbs to Nm (Newton metres) by using the following formula:

Multiply: by: to get:

ft/lbs x 1.3558 = Nm (Newton metres)

FASTENER TORQUE SPECIFICATIONS

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 115 116

Sin comentarios

Carrier operating and maintanance Especificaciones Pagina 95