Carrier operating and maintanance Especificaciones descargar pdf (Pagina 42)

5-376-000097

REV. 1 - 12/08

Section II: Operation

Page 32

7. Raise the Rollback Control

handle to slide the deck back.

Align the arrow decal pointer on

the side of the deck with the first

control handle. Tilting the

deck too soon may cause

damage to the mechanical

hold down.

8. Raise the Tilt Control handle to

raise the front of the deck until

the rear bumper rests firmly on

the ground.

9. Raise the Rollback Control

handle again to slide the deck

back. Continue sliding the deck

back until the approach plate

makes firm contact with the

ground. Make sure that the rear

bumper and the approach plate

are both in firm contact with the

ground before loading so there

is equal weight distribution

between the rear bumper and

the end of the deck.

10. Next, unreel enough of the wire

rope/cable from the winch to

make your hookup. If you are a

two man operation, raise the

winch control handle and unreel

the wire rope/cable from the

winch while the second man

keeps the wire rope/cable taut.

If you are a one man operation,

you can use the remote winch

free spool device. (See winch

operation)

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 115 116

Sin comentarios

Carrier operating and maintanance Especificaciones Pagina 42