Carrier 38TXA Guide Guía de usuario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 214
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
14 Chapter 2
S:\agilent\83217\OPT001\BOOK\CHAPTERS\tdscrip.fm
Test Descriptions
Introduction
Introduction
A test is made up of a series of programming commands which
configure the Test Set for a particular measurement environment. After
the Test Set is properly configured the desired measurement is made
and the measurement results are available to the user. One or more
tests make up a procedure. While you may change the tests that make
up a procedure, you may not change the measurements the test will
perform. For more information about test procedures, see “The Tests
Subsystem” in the Agilent 83217A Test Software User’s Guide.
Standards Used
The tests contained in this Test Package are derived from:
EIA/TIA IS-90 Recommended Minimum Performance Standards for
800 MHz Dual-Mode Narrowband Analog Cellular Subscriber Units
EIA/TIA IS-95 Mobile Station - Base Station Compatibility Standard
for Dual-Mode Wideband Spread Spectrum Cellular System
EIA/TIA IS-98 Recommended Minimum Performance Standards for
Dual-Mode Wideband Spread Spectrum Cellular Mobile Stations
With the exception of tests:
TEST_13 - TXA Current Drain
TEST_19 - RXA FVC Order Message Error Rate
Which are not derived from any particular standard, but instead are
derived from customer needs relating to standard mobile phone
operation.
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 213 214

Comentarios a estos manuales

Sin comentarios