Carrier 38TXA Guide Guía de usuario Pagina 162

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 214
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 161
162 Chapter 4
S:\agilent\83217\OPT001\BOOK\CHAPTERS\paramtr.fm
Parameter Descriptions
4. CPA MIN From? [0=RECC,1=All 0’s,2=Phone #]
4. CPA MIN From? [0=RECC,1=All 0’s,2=Phone
#]
This parameter specifies from where the Test Set will get the Mobile
Identification Number (MIN) of the MSUT.
Setting parameter 4 to 0=RECC causes the Test Set to get the MIN from
the Reverse Control Channel (RECC) Data. The RECC Data (data sent
on the control channel from the MSUT to the Test Set) sent during a
registration or an origination is read by the Test Set to obtain the MIN.
Setting parameter 4 to 1=All 0’s causes the Test Set to use a MIN
consisting of all zeros. An all zero MIN is an invalid MIN according to
the IS-95 standard. Because some phones initially have an all zero MIN
after being manufactured or serviced, this parameter (when set to
1=All 0’s) allows the Test Set to page phones with an all zero MIN.
NOTE
An all zero MIN can also be entered into the Test Set by setting
parameter 4 to 0=RECC and getting the MIN from the RECC Data from
a MSUT that has an all zero MIN.
NOTE
If parameter 4 is set to 1=All 0’s, then parameter 3. CPA Enter Ph#
[0=If Needed,1=Always,Here] is not used.
Setting parameter 4 to 2=Phone # causes the Test Set to derive the
MIN from the phone number, depending on the entry in parameter 3.
CPA Enter Ph# [0=If Needed,1=Always,Here] described below:
If parameter 3 contains a phone number, the phone number is used
to derive a MIN.
If parameter 3 is set to 0=If Needed or 1=Always, the user will be
prompted for a phone number if needed. This phone number will be
used to derive the MIN.
NOTE
If a registration or an origination test is performed that causes a new
MIN to be entered into the Test Set, this new MIN will then be used
instead of the MIN obtained as specified by parameter 4.
Vista de pagina 161
1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 213 214

Comentarios a estos manuales

Sin comentarios