Carrier 38TXA Guide Guía de usuario descargar pdf (Pagina 23)

Chapter 2 23

Test Descriptions

TEST_05 - TXA Modulation Deviation Limiting

Parameters Used

High and low supply voltages are measured only if an external power

supply has been configured to be used over GPIB by the test system and

if the parameter 20. RT Test at Extreme Settings [0=no 1=yes] is set to

1. See “TEST_13 - TXA Current Drain” on page 36 for details on

configuring an GPIB power supply.

• 1. CPA Control Channel [1-799 or 991 -1023]

• 2. CPA DSAT Vector

• 3. CPA Enter Ph# [0=If Needed,1=Always,Here]

• 4. CPA MIN From? [0=RECC,1=All 0’s,2=Phone #]

• 5. CPA Prt RECC RVC Data [0=no 1=yes 2=fail] 0

• 6. CPA SAT Tone (Hz)

• 14. RC Compandor is Always On [0=no 1=yes]

• 15. RT High Supply Voltage (Vdc)

• 16. RT Low Supply Voltage (Vdc)

• 17. RT Nominal Supply Voltage (Vdc)

• 20. RT Test at Extreme Settings [0=no 1=yes]

• 22. RX RF Level for Signaling (dBm)

• 42. TXA Frequency Deviation Step Frequency (kHz)

• 43. TXA Mod Dev Limit 50 Hz HPF [0=off 1=on]

• 49. TXA TS Atten for Signaling [0, 20, 40] (dB)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 213 214

Sin comentarios

Carrier 38TXA Guide Guía de usuario Pagina 23