
174 Chapter 4
S:\agilent\83217\OPT001\BOOK\CHAPTERS\paramtr.fm
Parameter Descriptions
16. RT Low Supply Voltage (Vdc)
16. RT Low Supply Voltage (Vdc)
This parameter is used to set the MSUT to its lowest specified voltage
rating. The value must be entered in Vdc with a range from 0 to 60.
Parameter 20. RT Test at Extreme Settings [0=no 1=yes] must be set to
“yes” for parameter 13. CPD Spectrum Averages [10,20,50,100] to be
activated.
The software requires that an GPIB programmable power supply be
used in order to adjust the voltage to the desired value. See parameter
20. RT Test at Extreme Settings [0=no 1=yes] on page 178 for more
information.
Example
If you desire the power supply voltage to operate the MSUT at −20% of
the normal (nominal) supply voltage, and the nominal supply voltage is
13.2 V, enter 10.6 as the parameter value.
Comentarios a estos manuales