Carrier 38TXA Guide Guía de usuario descargar pdf (Pagina 43)

Chapter 2 43

Test Descriptions

TEST_16 - RXA Audio Distortion

Description

This test measures the distortion from the receiver when a standard

test tone is applied to the radio.

NOTE

Audio connections from the radio to the test system are required for this

test.

Also, this test uses the C-Message audio filter or the CCITT audio filter

if it is installed in the test system.

•A

−50 dBm RF signal is applied to the receiver’s antenna.

•The

−50 dBm RF signal is modulated to deviate to 8 kHz at a 1 kHz

rate with a6000 Hz SAT tone present.

• Narrow analog operation uses 3 kHz deviation and DSAT.

Pass/Fail Limits Used

• 1. RXA Audio Distortion (%)

Parameters Used

• 1. CPA Control Channel [1-799 or 991 -1023]

• 2. CPA DSAT Vector

• 3. CPA Enter Ph# [0=If Needed,1=Always,Here]

• 4. CPA MIN From? [0=RECC,1=All 0’s,2=Phone #]

• 5. CPA Prt RECC RVC Data [0=no 1=yes 2=fail]

• 6. CPA SAT Tone (Hz)

• 14. RC Compandor is Always On [0=no 1=yes]

• 22. RX RF Level for Signaling (dBm)

• 31. RXA Set Audio Lvl [0=no xx=level volts]

• 32. RXA Tolerance for Setting Audio Level (% error)

• 49. TXA TS Atten for Signaling [0, 20, 40] (dB)

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 213 214

Sin comentarios

Carrier 38TXA Guide Guía de usuario Pagina 43